The following is an overview of the user manual for the Z-Wave product Doorbell Gateway (D1)from Starvedia. To view other Z-Wave products and manuals from Starvedia follow that link.
Overview
Plug & play by ID/password.
Control up to 120 Z-Wave devices.
Support Geo-Sense.
Control up to 60 scenes and hotkey, each scene allows 6 events and 12 actions.
Allow for 20 sets of user codes for the door lock.
Support Amazon Alex and Google Home.
Support IFTTT
Video recording on cloud.
Internal real time clock.
Watchdog function to prevent system failure.
Security
As a Z-Wave Plus certified product, Doorbell Gateway supports Z-Wave S2 security. The following security modes are directly supported:
- S2 Access Control
- S2 Authenticated
- S2 Unauthenticated
Features
Starvedia describes Doorbell Gateway as having the following features:
- Communications Connections
- Communications Protocol
- Firmware updatable via a compatible Z-Wave gateway
- Sensors
- Supported Notification Types
- Switch Load Capacity Current
- Switch Load Capacity Volt-Ampere
- Switch Load Capacity Watts
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
Open the App mCamviewZ+ and press the ""+"" button under the ""Device"" menu, the camera will go into inclusion mode. User can now trigger the Z-Wave device into its inclusion mode and add it to the camera's Z-Wave network.
Open the App mCamviewZ+ and press the ""-"" button under the ""Device"" menu, the camera will go into exclusion mode. User can now trigger the Z-Wave device into its exclusion mode and remove it from the camera's Z-Wave network.
Open the App mCamviewZ+ and go to ""Home Settings"" > ""Camera settings"" > ""Admin"" > ""Z-Wave administration"" page, click ""Z-Wave Learn Mode"" will put the camera into learn mode
Factory reset Doorbell Gateway
Open the App mCamviewZ+ and go to ""Home Settings"" > ""Camera settings"" > ""Admin"" > ""Z-Wave administrator"" page, click ""Z-Wave Reset"" will reset the Z-Wave Settings of the camera.
If this controller is the primary controller for your network, resetting it will result in the nodes in your network being orphaned and it will be necessary after the reset to exclude and re-include all of the nodes in the network. If this controller is being used as a secondary controller in the network, use this procedure to reset this controller only in the event that the network primary controller is missing or otherwise inoperable.
Please note that this is a user manual Doorbell Gateway from Starvedia is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Doorbell Gateway and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.