The following is an overview of the user manual for the Z-Wave product Smart home camera gateway (IC731z)from Starvedia. To view other Z-Wave products and manuals from Starvedia follow that link.
Overview
Working with Amazon Echo(Alexa)
Compatible with all Z-Wave devices
Easy device, room and scene control
One mega-pixel camera, 1280x800, 30 fps
340 degree Pan and 90 degree tilt
Day and night with IR led
Two-way audio
Time lapse video recording
SD card and Cloud storage
Smart home iOS and Android App
Security
As a Z-Wave Plus certified product, Smart home camera gateway supports Z-Wave S2 security. The following security modes are directly supported:
Features
Starvedia describes Smart home camera gateway as having the following features:
- Switch Load Capacity Current
- Firmware updatable via a compatible Z-Wave gateway
- Communications Protocol
- Switch Load Capacity Volt-Ampere
- Communications Connections
- Switch Load Capacity Watts
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
Open the App mCamviewZ+ and go to ""Home Settings"" > ""Camera settings"" > ""Admin"" > ""Z-Wave administration"" page, click ""Z-Wave Learn Mode"" will put the camera into learn mode
Open the App mCamviewZ+ and press the ""+"" button under the ""Device"" menu, the camera will go into inclusion mode. User can now trigger the Z-Wave device into its inclusion mode and add it to the camera's Z-Wave network.
Factory reset Smart home camera gateway
Open the App mCamviewZ+ and go to ""Home Settings"" > ""Camera settings"" > ""Admin"" > ""Z-Wave administrator"" page, click ""Z-Wave Reset"" will reset the Z-Wave Settings of the camera.
If this controller is the primary controller for your network, resetting it will result in the nodes in your network being orphaned and it will be necessary after the reset to exclude and re-include all of the nodes in the network. If this controller is being used as a secondary controller in the network, use this procedure to reset this controller only in the event that the network primary controller is missing or otherwise inoperable.
Open the App mCamviewZ+ and press the ""-"" button under the ""Device"" menu, the camera will go into exclusion mode. User can now trigger the Z-Wave device into its exclusion mode and remove it from the camera's Z-Wave network.
Please note that this is a user manual Smart home camera gateway from Starvedia is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Smart home camera gateway and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.