The following is an overview of the user manual for the Z-Wave product Staybinder Smart Door Lock (GKBC-3100Z)from Staybinder powered by KeyWe. To view other Z-Wave products and manuals from Staybinder powered by KeyWe follow that link.
Overview
You can control the door lock directly from the phone via the Bluetooth function in close range. You can also check the status of the door lock on the outside by connecting to the Z-Wave hub.
Security
As a Z-Wave Plus certified product, Staybinder Smart Door Lock supports Z-Wave S2 security. The following security modes are directly supported:
- S2 Access Control
Features
Staybinder powered by KeyWe describes Staybinder Smart Door Lock as having the following features:
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
Please proceed with the door lock open.
1. Set the controller in inclusion mode.
2. Open the battery cover of the indoor body and press the [REG] button.
3. Press the Master Pin [1][2][3][4] (Default value) button after pressing the [#] button.
4. Press the [8][8] button after pressing the [*] button.
Please proceed with the door lock open.
1. Set the controller in exclusion mode.
2. Open the battery cover of the indoor body and press the [REG] button.
3. Press the Master Pin [1][2][3][4] (Default value) button after pressing the [#] button.
4. Press the [9][9] button after pressing the [*] button.
Factory reset Staybinder Smart Door Lock
Please proceed with the door lock open.
Please use this procedure only when the primary controller is missing or otherwise inoperable.
1. Open the battery cover of the indoor body and press the [REG] button.
2. Press the Master Pin [1][2][3][4] (Default value) button after pressing the [#] button.
3. Press the [5] button after pressing the [*] button.
4. Press the [2] button after pressing the [*] button.
5. Press the Master Pin [1][2][3][4] (Default value) button after pressing the [#] button
*Master pins can change user settings.
SmartStart location
SmartStart QR code's location as follows: DSK number is posted below location.
1) Product : Left side of Indoor Body
2) Package Box : Rear Right Top
To wake up the product, the following actions are required.
1. Touch the keypad on outdoor body.
2. Push the button on Indoor body.
3. Turn the knob on Indoor body.
Please note that this is a user manual Staybinder Smart Door Lock from Staybinder powered by KeyWe is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Staybinder Smart Door Lock and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.