The following is an overview of the user manual for the Z-Wave product Motion Switch LED (40111665101)from Steinel GmbH. To view other Z-Wave products and manuals from Steinel follow that link.
Overview
One product, four features, many possibilities: The MotionSwitch LED Z-Wave is a motion detector, brightness sensor, pushbutton and orientation light in one. No cable laying, no battery change - just plug it into the socket and off you go. The smart sensor can be quickly and easily integrated into Z-Wave based Smart Home systems like Smart Friends, making our everyday life smarter. For example, through automatic corridor lighting as soon as the 180 ° infrared sensor with a range of 20 m detects movement. Or by automatically darkening as soon as a certain degree of brightness is reached. Thanks to the integrated button, actuators, for example a radio, can be switched on manually. And the automatic orientation light ensures good visibility at night with 3000 K. Smart Home can be so easy!
Security
As a Z-Wave Plus certified product, Motion Switch LED supports Z-Wave S2 security. The following security modes are directly supported:
- S2 Unauthenticated
Features
Steinel describes Motion Switch LED as having the following features:
- Firmware updatable via a compatible Z-Wave gateway
- Switch Type
- Color
- Supported Notification Types
- Sensors
- Z-Wave Scene Type
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
To start the motion detector's inclusion or exclusion mode,
press the button three times in rapid succession.
During inclusion and following configuration process the device is blinking.
To start the motion detector's inclusion or exclusion mode,
press the button three times in rapid succession.
During exclusion the device is blinking.
Factory reset Motion Switch LED
Please only perform these steps if the main network controller is missing or not working for other reasons.
1 To set the sensor to ""Reset"", press the button three times in rapid
succession and then press it once for several seconds.
2 The device is now no longer included in the Z-Wave system and has been returned to factory settings
Please note that this is a user manual Motion Switch LED from Steinel GmbH is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Motion Switch LED and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.