The following is an overview of the user manual for the Z-Wave product Cam+ (SW-ZCAM1)from Swiid. To view other Z-Wave products and manuals from Swiid follow that link.
Overview
Works with Amazon Echo(Alexa) and Google Home and is IFTTT compatible
Controls up to 60 Z-Wave devices
Supports Z-Wave devices inclusion and control, room control and scene control via free iOS and Andoid View and Control App (SwiidCam+View)
One mega-pixel camera, 1280x800, 30 fps with H.264 video compression
340 degree pan and 90 degree tilt control
Up to 5 video view presets
Day and night with IR led
in-built light, sound and motion sensors
Allows alarm notification for each Z-Wave devices and each scene
Two-way audio
Time lapse video recording
SD card and Cloud storage
Smart home iOS and Android App
802.11 n wireless with WEP and WPA/WPA2 security support.
WPS (WiFi Protected Setup) support
Security
As a Z-Wave Plus certified product, Cam+ supports Z-Wave S2 security. The following security modes are directly supported:
Features
Swiid describes Cam+ as having the following features:
- Firmware updatable via a compatible Z-Wave gateway
- Communications Connections
- Sensors
- Supported Notification Types
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
Open the App mCamviewZ+ and press the ""+"" button under the ""Device"" menu, the camera will go into inclusion mode. User can now trigger the Z-Wave device into its inclusion mode and add it to the camera's Z-Wave network.
Open the App mCamviewZ+ and press the ""-"" button under the ""Device"" menu, the camera will go into exclusion mode. User can now trigger the Z-Wave device into its exclusion mode and remove it from the camera's Z-Wave network.
Open the App mCamviewZ+ and go to ""Home Settings"" > ""Camera settings"" > ""Admin"" > ""Z-Wave administration"" page, click ""Z-Wave Learn Mode"" will put the camera into learn mode
Factory reset Cam+
Open the App mCamviewZ+ and go to ""Home Settings"" > ""Camera settings"" > ""Admin"" > ""Z-Wave administrator"" page, click ""Z-Wave Reset"" will reset the Z-Wave Settings of the camera.
If this controller is the primary controller for your network, resetting it will result in the nodes in your network being orphaned and it will be necessary after the reset to exclude and re-include all of the nodes in the network. If this controller is being used as a secondary controller in the network, use this procedure to reset this controller only in the event that the network primary controller is missing or otherwise inoperable.
Please note that this is a user manual Cam+ from Swiid is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Cam+ and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.