The following is an overview of the user manual for the Z-Wave product Talk-Z (MPU100ZW)from Talk-Z. To view other Z-Wave products and manuals from Talk-Z follow that link.
Overview
Talk-Z is physically installed between Z-Wave devices and Wi-Fi AP benefits to extend wireless coverage more than double.
Built-in AC plug on Smart Home Bridge makes easy to install.
Talk-Z has two buttons, that one for Z-Wave pairing and the other one for Wi-Fi connection.
Security
As a Z-Wave Plus certified product, Talk-Z supports Z-Wave S2 security. The following security modes are directly supported:
Features
Talk-Z describes Talk-Z as having the following features:
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
2. From the Talk-Z page, select Remove Device.
2. Click Go button.
Now that the gateway is looking for a device to remove, the device must allow itself to be found.This process depends on the devcie. Putting the device into remove mode may require pressing a button or removing a battery. Consult the manufacturer's documentation packaged with the device for details;
Instructions for many devices can be found on manufacturer's websites.
3. After the device is disconnected, the deleted device is disappeared in the Talk-Z page.
How to add Talk-Z as a secondary controller into an existed estbablised network.
1. From the Talk-Z Page(web page), select Learn Mode.
2. Click Go button.
3. Enter Add Mode on the primary or inclusion controller
4. If this mode is successful, you can see the device's information in the Talk-Z Page(web page).
1. From the Talk-Z page (web page), select Add Device or Add Device (Secure).
2. Click Go button.
Now that the Talk-Z is looking for a device, the device must allow itself to be found. This process depends on the device. Some have a button, perhaps labeled ""Add"" or ""Include"" that you must press. Others enter the Add mode simply by inserting a battery or removing a plastic strip separating the battery from a contact. Consult the manufacturer's documentation packaged with the device for details; Instructions for many devices can be found on manufacturer's websites.
3. After the device is connected, you can see the device's information in the Talk-Z Page (web page)
Factory reset Talk-Z
Use this procedure only in the event that the network primary controller is missing or otherwise inoperable. If Talk-Z is your primary controller, use of this procedure could result in your Z-Wave devices being orphaned and having no central controller to communicate with; use this procedure with caution.
This implies that Z-Wave network back to its factory settings
1. From the Talk-Z page, press the Reset button.
2. To confirm reset, press the yes button.
3. If this process is successful, All node information disappeared in Talk-Z
Please note that this is a user manual Talk-Z from Talk-Z is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Talk-Z and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.