The following is an overview of the user manual for the Z-Wave product Single-Switch (0x00/9499)from TechniSat. To view other Z-Wave products and manuals from TechniSat follow that link.
Overview
Featuring Z-Wave SmartStart and S2 security for easy installation and secure operation, your wall switch can now be controlled from your Smart Home as well.
● Full manual operation
● can trigger central scenes via multiple button clicks
● Integrated 230 V auxiliary input for push buttons or toggle switch types, applicable in alternating switching and or intermediate switching circuits
● Short circuit and overload protection monitoring
Security
As a Z-Wave Plus certified product, Single-Switch supports Z-Wave S2 security. The following security modes are directly supported:
- S2 Authenticated
- S2 Unauthenticated
Features
TechniSat describes Single-Switch as having the following features:
- Neutral Wire Required
- Firmware updatable via a compatible Z-Wave gateway
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
1. Start the Z-Wave device remove mode on your Z-Wave gateway, according to the gateway‘s manual.
2. Press and hold position T1 for more than 10 seconds.
3. The red status LED is on while the device is removed from the Z-Wave network.
4. The green LED is on for 5 seconds after successfully removing the device.
Factory reset Single-Switch
Use this procedure only when the network primary controller is missing or otherwise inoperable.
1. Press and hold position T2 for more than 20 seconds.
2. The LED will alternately flash red and green for 5 seconds after a successful reset.
SmartStart location
SmartStart QR code's location as follows: The Z-Wave QR-Code is located on the back of the product.
1. Install the TechniSat Single-Switch.
2. After checking the correct installation, re-enable electrical power at the main fuse or circuit breaker.
3. Start the Z-Wave device add mode on your Z-Wave gateway, according to the gateway‘s manual.
4. Press position T1 3x within 1 second.
5. The red status LED is on while the device is added to the Z-Wave network.
6. The green LED is on for 5 seconds after successfully adding the device.
Please note that this is a user manual Single-Switch from TechniSat is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Single-Switch and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.