Z-Wave Stick 1 (0000/9536) manual for Z-Wave

The following is an overview of the user manual for the Z-Wave product Z-Wave Stick 1 (0000/9536)from TechniSat. To view other Z-Wave products and manuals from TechniSat follow that link.

  1. Overview
  2. Security
  3. Features
  4. Installation instructions


Z-Wave Stick 1
SKU Code
Unleash the full potential of your TechniSat Smart Home Ready Receiver or Television with TechniSat's Z-Wave Stick 1. Bring "Smart" to your home with the TechniSat devices you already own.

TechniSat's Z-Wave Stick 1 enables Z-Wave certified controller software applications supporting the Bridge Controller library to perform Z-Wave network operations - it cannot do Z-Wave network operations on its own.
Version #
HW: 0 FW: ERROR was the version certified
Certification #
Z-Wave Version


As a Z-Wave Plus certified product, Z-Wave Stick 1 supports Z-Wave S2 security. The following security modes are directly supported:


    TechniSat describes Z-Wave Stick 1 as having the following features:

    • Firmware updatable via a compatible Z-Wave gateway
    • Communications Connections
    • Communications Protocol
    • FLiRS capable
    • Supports Network Wide Inclusion
    • Supports Z-Wave Explorer Frames
    • Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via

    Installation instructions

    Please note that this is a user manual Z-Wave Stick 1 from TechniSat is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Z-Wave Stick 1 and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.