The following is an overview of the user manual for the Z-Wave product FlexHub (TGFX-HUB1)from Telguard. To view other Z-Wave products and manuals from Telguard follow that link.
Overview
Security
As a Z-Wave Plus certified product, FlexHub supports Z-Wave S2 security. The following security modes are directly supported:
Features
Telguard describes FlexHub as having the following features:
- Color
- Firmware updatable via a compatible Z-Wave gateway
- Communications Connections
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
In the mobile app, tap the Add button. A flashing Z-Wave LED indicates the FlexHub is in inclusion mode. Follow the device manufacturer's instructions to place the device in learn mode. The FlexHub will remain in inclusion mode for 1 minute or until the new device is found.
In the mobile app, tap the icon of the device to be removed. From the device details page tap the Delete Device button. A flashing Z-Wave LED indicates the FlexHub is in exclusion mode. Follow the device manufacturer's instructions to place the device in learn mode. The FlexHub will remain in exclusion mode for 1 minute or until the device is removed.
Follow the manufacturer's instructions to place another controller in inclusion mode. Then in the mobile app, select the right arrow at the upper right of the Devices tab. Tap the Op Learn Command button to place the FlexHub into learn mode.
Factory reset FlexHub
To return the FlexHub to factory defaults, use a pin or paper clip to press the recessed Reset button for 15 seconds. Observe the marquee pattern on the LEDs indicating the factory default is complete.
Note that if the FlexHub is the primary controller for your network, resetting it to factory defaults will result in the nodes in your network being orphaned. It will be necessary after the reset to exclude and re-include all of the nodes in the network. If the FlexHub is being used as a secondary controller in the network, return to factory defaults only in the event that the network primary controller is missing or otherwise inoperable.
Please note that this is a user manual FlexHub from Telguard is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have FlexHub and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.