Categories

Aeotec

Atrim

SmartThings

Z-Wave Products

Door/window sensor (TZDW-100) manual for Z-Wave

The following is an overview of the user manual for the Z-Wave product Door/window sensor (TZDW-100)from Telldus. To view other Z-Wave products and manuals from Telldus follow that link.

  1. Overview
  2. Security
  3. Features
  4. Installation instructions

Overview

Name
Door/window sensor
SKU Code
TZDW-100
Description
This magnet sensor contains the latest Z-Wave technology with the ability to remotely control other Z-Wave units available in your network. The fact that it is battery operated and so small you can virtually place it anywhere you want – on doors, windows or drawers, without the need of wiring. Screw or tape up the holder and then click the sensor in place. Done! The sensor is designed to be seen as little as possible and we have made it significantly smaller than other sensors. It consists of two parts that will merge into a stylish unit when the sensor is closed.
Version #
01 was the version certified
Certification #
ZC10-15100003
Certified
2015-09-25T15:35:33.3512
Z-Wave Version
6.51.06

Security

As a Z-Wave Plus certified product, Door/window sensor supports Z-Wave S2 security. The following security modes are directly supported:

    Features

    Telldus describes Door/window sensor as having the following features:

    • FLiRS capable
    • Supports Network Wide Inclusion
    • Supports Z-Wave Explorer Frames
    • Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via

    Installation instructions

    Factory reset Door/window sensor

    Press and hold the button until the LED starts flashing (approx. 6 seconds).
    Press the button once more, short.
    The device will now reset to factory defaults. The LED will now flash, indicating that it’s no longer added in any Z-Wave network.

    Please note! Only use the reset procedure when the primary controller is missing or inoperable.

    Press the button on the sensor one time short to wake up the device.

    Automatically add device to network
    When a battery is inserted, the device is in automatical add mode for one minute (Network Wide Inclusion, NWI). This means that the device is added automatically when the Z-Wave controller enters add mode.

    Manual add device to network
    Start the add mode on the Z-Wave controller. Press the button on the device three times fast. The device will now be added into the Z-Wave-network.

    Start the exclusion mode on the Z-Wave controller. Press the button on the device three times fast. The device will now be removed from the Z-Wave-network.

    Please note that this is a user manual Door/window sensor from Telldus is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Door/window sensor and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.