The following is an overview of the user manual for the Z-Wave product Plug-in Switch (Schuko) (TZWP-100)from Telldus. To view other Z-Wave products and manuals from Telldus follow that link.
Overview
Security
As a Z-Wave Plus certified product, Plug-in Switch (Schuko) supports Z-Wave S2 security. The following security modes are directly supported:
Features
Telldus describes Plug-in Switch (Schuko) as having the following features:
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
Tripple click the button on the device
Tripple click the button on the device
Factory reset Plug-in Switch (Schuko)
Press and hold the button until the LED starts flashing white (approx. 6 seconds).
Press the button once more, short.
Please note! Only use the reset procedure when the primary controller is missing or inoperable.
Please note that this is a user manual Plug-in Switch (Schuko) from Telldus is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Plug-in Switch (Schuko) and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.