The following is an overview of the user manual for the Z-Wave product Zpad V3.4 (TLJ ZPAD)from TLJ Access Control. To view other Z-Wave products and manuals from TLJ Access Control follow that link.
Overview
Security
As a Z-Wave Plus certified product, Zpad V3.4 supports Z-Wave S2 security. The following security modes are directly supported:
- S2 Access Control
Features
TLJ Access Control describes Zpad V3.4 as having the following features:
- Battery Quantity
- Battery powered using AA batteries
- Color
- Communications Connections
- Communications Protocol
- Door Lock Type
- Firmware updatable via a compatible Z-Wave gateway
- IP (Ingress Protection) Rated
- Outdoor Use
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
SmartStart location
SmartStart QR code's location as follows: DSK usually print on the main body
Simply by touching the front main panel touch screen keypad, anywhere will wake-up the Zpad.
Factory reset Zpad V3.4
Remove the Zpad from the wall, and locate the "SET" button on the backside. Press & Hold this button for the required duration to perform the factory reset A, B or C. Please note regarding reset type C - Please use this procedure only when the network primary controller is missing or otherwise inoperable.
Please note that this is a user manual Zpad V3.4 from TLJ Access Control is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Zpad V3.4 and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.