The following is an overview of the user manual for the Z-Wave product Xl824 (TCONT824AS52DBA)from Trane. To view other Z-Wave products and manuals from Trane follow that link.
Overview
Security
As a Z-Wave Plus certified product, Xl824 supports Z-Wave S2 security. The following security modes are directly supported:
Features
Trane describes Xl824 as having the following features:
- Color
- Communications Protocol
- Firmware updatable via a compatible Z-Wave gateway
- Gateway Has Preferred Partners
- Sensors
- Supported Notification Types
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
To add the bridge to an existing network, follow your primary controller’s instructions to put the primary controller into Add Mode. Then press the Learn button on the bridge.
From the HOME Screen, press MENU, NEXIA, ADVANCED, then LEARN.
This function copies a new Z-Wave network to the bridge from another controller. This function is not allowed if your bridge is a primary controller with included Z-Wave devices.
From the HOME Screen, press MENU, then press NEXIA.
Press ADD DEVICE and follow the device manufacturer’s instructions for setting the Z-Wave device into learn mode. You will have four minutes to set the device into learn mode after pressing the ADD DEVICE button.
From the HOME Screen, press MENU, then press NEXIA.
Press REMOVE DEVICE and follow the manufacturer’s instructions for setting the Z-Wave device into learn mode. You will have four minutes to set the device into learn mode after pressing the REMOVE DEVICE button.
Factory reset Xl824
From the HOME Screen, press MENU, NEXIA, ADVANCED, then FACTORY RESET.
Resets all Z-Wave information and removes all devices from the bridge. If this bridge is the primary controller for your network, resetting it will result in all the devices in your network being removed. Following the reset, it will be necessary to remove and then add all of the devices back to your network.
If this bridge is being used as a secondary or inclusion controller in the network, please reset this bridge only in the event that the primary controller is missing or otherwise inoperable.
Please note that this is a user manual Xl824 from Trane is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Xl824 and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.