The following is an overview of the user manual for the Z-Wave product Auto Valve (GR-105)from U-Fairy G.R. IOT Tech Co. ltd. To view other Z-Wave products and manuals from U-Fairy follow that link.
Overview
Security
As a Z-Wave Plus certified product, Auto Valve supports Z-Wave S2 security. The following security modes are directly supported:
Features
U-Fairy describes Auto Valve as having the following features:
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
1. Follow the instructions for your Z-wave certified controller to include a device to the Z-wave network.
2.Once the controller is ready to include your device, press the red button 3 times to include it in the Z-wave network.
1. Follow the instructions for your Z-wave certified controller to exclude a device to the Z-wave network.
2.Once the controller is ready to exclude your device, press the red button 3 times to exclude it from the Z-wave network.
Factory reset Auto Valve
Press and hold the button 10 seconds and release the button. The device will send the reset notification to the list node in the group1 and erases the device memory , when the light flash it is resetting success.
Note: This should only be used in the event your networks primary controller is missing or otherwise inoperable.
Please note that this is a user manual Auto Valve from U-Fairy G.R. IOT Tech Co. ltd is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Auto Valve and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.