The following is an overview of the user manual for the Z-Wave product Door/Window detector (GR-309N)from U-Fairy G. R.. To view other Z-Wave products and manuals from U-Fairy follow that link.
Overview
Security
As a Z-Wave Plus certified product, Door/Window detector supports Z-Wave S2 security. The following security modes are directly supported:
Features
U-Fairy describes Door/Window detector as having the following features:
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
press the Z-Wave button 1 time in the door sensor when the Z-Wave controller sends the instructions for inclusion or Add new devices.
press the Z-Wave button 1 time in the door sensor when the Z-Wave controller sends the instructions for exclusion or Remove devices
Factory reset Door/Window detector
Press the button 6 times the device will send the reset notification to the list node in the group 1 and erases the device memory, when the light flash is resetting success
""Use this procedure only in the event that the network primary controller is missing or otherwise inoperable.""
Press the button 1time the led will turn on and wakeup
Please note that this is a user manual Door/Window detector from U-Fairy G. R. is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Door/Window detector and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.