The following is an overview of the user manual for the Z-Wave product PIR Sensor (GR-302N)from U-Fairy G. R.. To view other Z-Wave products and manuals from U-Fairy follow that link.
Overview
Security
As a Z-Wave Plus certified product, PIR Sensor supports Z-Wave S2 security. The following security modes are directly supported:
Features
U-Fairy describes PIR Sensor as having the following features:
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
Please press the Z-Wave button in the pir sensor when the Z-Wave controller sends the instructions for inclusion, Press the Button: unlock and lock-unlock 1 time will send the NIF
Please press the Z-Wave button in the pir sensor when the Z-Wave controller sends the instructions for exclusion, Times to Press the Button: unlock and lock-unlock 1 time will send the NIF
Press the button unlock and lock-unlock 1 time it will be wake up 10 seconds.
Factory reset PIR Sensor
Press the button unlock and lock-unlock 6 times the device will send the reset notification to the list node in the group 1 and erases the device memory.
Use this procedure only in the event that the network primary controller is missing or otherwise inoperable.
Please note that this is a user manual PIR Sensor from U-Fairy G. R. is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have PIR Sensor and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.