The following is an overview of the user manual for the Z-Wave product Power Switch (GR-201N)from U-Fairy G. R.. To view other Z-Wave products and manuals from U-Fairy follow that link.
Overview
This module will send On/Off signal to the appliance that attached to this module by receiving Z-Wave™ signal from controller or manually switch. This module also acts as repeater and can also be used in other manufacturer’s Z-Wave™ enabled networks.
Security
As a Z-Wave Plus certified product, Power Switch supports Z-Wave S2 security. The following security modes are directly supported:
Features
U-Fairy describes Power Switch as having the following features:
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
Please press the Z-Wave button when the Z- Wave controller sends the instructions for inclusion, Press the Button 3 times it will send the NIF
Please press the Z-Wave button when the Z-Wave controller sends the instructions for exclusion, Press the Button: 3 times it will send the NIF
Factory reset Power Switch
Press and hold the button 10 seconds . The device will send the reset notification to the list node in the group1 and erases the device memory.
Note: This should only be used in the event your networks primary controller is missing or otherwise inoperable.
Please note that this is a user manual Power Switch from U-Fairy G. R. is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Power Switch and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.