The following is an overview of the user manual for the Z-Wave product Hub (DMGW1)from Ubitech. To view other Z-Wave products and manuals from Ubitech follow that link.
Overview
·Instant Plug and Play Setup - New Sensors set-up simply by turning them on. The Hub seeks
them out and adds them to the Home Network
·Remote Firmware Upgrades - Hub receives automatic upgrades with new features and fixes
from the Cloud with little or no user involvement
·Network Control - Works with most leading Home Automation network devices
·Z-Wave+ Certification ensures the highest level of Security Encryption in Wireless Communication
·Battery Back-up - Can run for 4 hours on 4 Ni-MH Rechargeable Batteries when power is out
·1 Year limited Warranty
Security
As a Z-Wave Plus certified product, Hub supports Z-Wave S2 security. The following security modes are directly supported:
Features
Ubitech describes Hub as having the following features:
- Battery Quantity
- Gateway Has Preferred Partners
- Firmware updatable via a compatible Z-Wave gateway
- Battery powered using 1.2V AA NiMH Rechargeable batteries batteries
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
User can install 4 NiMH battery as power back up, in this case Z-Box can run 6 hours during power interruption.
The device management box shows the status of the controller. The “(Re-)Include Device” the controller into the Inclusion resp. The inclusion modes will time out after about 20 seconds but can always be terminated using the “Stop” buttons.
The device management box shows the status of the controller. The “Exclude Device” the controller into the Exclusion resp. The exclusion modes will time out after about 20 seconds but can always be terminated using the “Stop” buttons.
Clicking the “Learn” button turns the controller in a function where it will accept inclusion requests from other controllers. The controller status dialog on the upper left hand side shows this status. The Learn mode will time out after about 20 seconds or when the device was included successfully. It is also possible to manually terminate the mode.
Factory reset Hub
To reset the Network to the default settings, press and hold the Main button(on top of the Z-box) for 10 seconds. Release the button when the LED quickly flashes red indicating reset. Refer to the Dome App to reconnect the Z-box.
If this controller is the primary controller for your network, resetting it will result in the nodes in your network being orphaned and it will be necessary after the reset to exclude and re-include all of the nodes in the network. If this controller is being used as a secondary controller in the network, use this procedure to reset this controller only in the event that the network primary controller is missing or otherwise inoperable.
Please note that this is a user manual Hub from Ubitech is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Hub and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.