The following is an overview of the user manual for the Z-Wave product U-Bolt Z-Wave Smart Lock (U-BOLT-ZWAVE)from Ultraloq. To view other Z-Wave products and manuals from Ultraloq follow that link.
Overview
Security
As a Z-Wave Plus certified product, U-Bolt Z-Wave Smart Lock supports Z-Wave S2 security. The following security modes are directly supported:
- S2 Access Control
Features
Ultraloq describes U-Bolt Z-Wave Smart Lock as having the following features:
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
SmartStart location
SmartStart QR code's location as follows: If your Z-Wave hub is Security 2 enabled and requires the Z-Wave QR code or pin code to add the lock automatically, please find it on the back of the battery cover of your smart lock.
This process can only be done once the lock is Set up and connected in the U-tec App.
Step1
Set the Z-Wave network main controller or hub into inclusion mode.
Step2
Open the U-tec App and go to Settings, select Z-Wave Control. The App should state that “Your Ultraloq Smart Lock has not been added to a Z-Wave hub yet”.
If your lock has been added to a hub already, please follow the instructions to exclude your lock from the hub first.
Step3
Tap Add to Z-Wave hub,then follow the App instructions to start the inclusion process. If your Z-Wave hub is Security 2 enabled and requires the Z-Wave QR code or pin code to add the lock automatically, please find it on the back of the battery cover of your smart lock.
When U-tec App states that the connection is successful, please return to your hub interface to complete the setup.
This process can only be done once the lock is Set up and connected in the U-tec App. Step1
Set the Z-Wave network main controller or hub into exclusion mode.
Step2
Open U-tec App，go to Lock Settings, select Z-Wave Control, tap Remove my lock from
Z-Wave hub, then follow the App instructions to complete the process.
1. Touch the keypad on outdoor body.
2. Turn the knob on Indoor body.
3. Touch unlock button in the U-tec App
Factory reset U-Bolt Z-Wave Smart Lock
CAUTION: Resetting a Z-Wave device without notifying the hub may cause performance problems. Use this procedure only when the Z-Wave hub is missing or otherwise inoperable.
If you are using U-tec App as Owner, please click “Delete and Reset” to remove the lock from your U-tec Account, then use a Reset Needle to push the Reset Button (at the bottom of Interior Assembly) for around 3 seconds until you hear one long beep and two short beeps.
If U-Bolt Z-Wave is working as Standalone Mode without the App, please use a Reset Needle to push the Reset Button (at the bottom of Interior Assembly) for around 3 seconds until you hear one long beep and two short beeps.
Please note that this is a user manual U-Bolt Z-Wave Smart Lock from Ultraloq is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have U-Bolt Z-Wave Smart Lock and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.