eVI WISE (WISE-AC-01) manual for Z-Wave

The following is an overview of the user manual for the Z-Wave product eVI WISE (WISE-AC-01)from VENTURE INDUSTRIES SP. Z O. O.. To view other Z-Wave products and manuals from Venture Industries follow that link.

Overview
Security
Features
Installation instructions

Overview

Name

eVI WISE

SKU Code

WISE-AC-01

Description

eVI WISE is a Z-Wave™ device that allows control the air flow through the fan. Evi WISE fan is a device designed for rooms like kitchens and bathrooms and is meant to extract used air, excess humidity and bad smells. It is a highly efficient device designed with balance between power, sound level and energy consumption. It is equipped with a Z-Wave module and integrated humidity and temperature sensor. Evi WISE fan is a main part in the Venture WISE system.

Version #

HW: 01 FW: 07.01 was the version certified

Certification #

ZC14-23010185

Certified

2023-01-05T12:36:30

Z-Wave Version

7.18.1

Security

As a Z-Wave Plus certified product, eVI WISE supports Z-Wave S2 security. The following security modes are directly supported:

S2 Authenticated
S2 Unauthenticated

Features

Venture Industries describes eVI WISE as having the following features:

FLiRS capable
Supports Network Wide Inclusion
Supports Z-Wave Explorer Frames
Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via

Installation instructions

SmartStart location

SmartStart QR code's location as follows: 4.2: Adding using SmartStart page 9

To add the device to the Z-Wave network manually:
1. Set the main controller in (Security/non-Security Mode) add mode (see the controller’s manual).
2. Set the device in learning mode by single-clicking the button on the PCB (Fig. 3).
3. If you are adding in Security S2 Authenticated, input the underlined part of the DSK

To remove the device from the Z-Wave network:
1. Set the main controller into remove mode (see the controller’s manual).
2. Click once on the PCB button (Fig. 3).
3. Wait for the removal process to complete.

Factory reset eVI WISE

1. To restore the device to the factory settings, hold down the button located on the PCB for at least 5 seconds (Fig. 3).
2. Wait for the reset procedure to complete.

Please note that this is a user manual eVI WISE from VENTURE INDUSTRIES SP. Z O. O. is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have eVI WISE and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.

Categories