The following is an overview of the user manual for the Z-Wave product Z-Wave to Systemair HVAC Adapter (29990)from Villavent. To view other Z-Wave products and manuals from Villavent follow that link.
As a Z-Wave Plus certified product, Z-Wave to Systemair HVAC Adapter supports Z-Wave S2 security. The following security modes are directly supported:
Villavent describes Z-Wave to Systemair HVAC Adapter as having the following features:
- Firmware updatable via a compatible Z-Wave gateway
- Thermostat HVAC Systems Supported
- Thermostat Modes
- Thermostat Power Source
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
When the device is not added to a Z-Wave network, then triple short clicks of the inclusion button will start the inclusion.
When the device is already included in a Z-Wave network, then triple short clicks of the inclusion button will exclude it from that Z-Wave network.
Factory reset Z-Wave to Systemair HVAC Adapter
To do a Factory Reset the user must follow the following procedure:
- Press and hold the inclusion button for 6 seconds, then
- Release it, and then
- Press it again and hold it for 3 seconds
The Z-Wave Adapter is indicating each phase with a different LED pattern – see “Operational modes and indicators” in the User's Manual.
Please note that this is a user manual Z-Wave to Systemair HVAC Adapter from Villavent is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Z-Wave to Systemair HVAC Adapter and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.