The following is an overview of the user manual for the Z-Wave product 2 in 1 Universal Remote (ZA1502JP-7)from Vision. To view other Z-Wave products and manuals from Vision follow that link.
Overview
- Scene Control
- Arm/Disarm
- On/Off Control
- Emergency Help
Security
As a Z-Wave Plus certified product, 2 in 1 Universal Remote supports Z-Wave S2 security. The following security modes are directly supported:
- S2 Authenticated
- S2 Unauthenticated
Features
Vision describes 2 in 1 Universal Remote as having the following features:
- Battery Quantity
- Battery powered using CR2032 batteries
- Color
- Firmware updatable via a compatible Z-Wave gateway
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
For “Exclusion” from (removing from) a network: Put the Z-Wave™ Interface Controller into “exclusion” mode, and following its instruction to delete the ZA1502-7 from your controller. Quick press the button of ZA1502-7 5 times to be excluded, the Red/Green LED will flash 5 times quickly after successful exclusion.
Note: All user and network settings will be cleared and the device reset to factory defaults when the device is excluded.
Wake Up Notification:
Press the button of ZA1502-7 2 times will active the “Wake Up Mode” for receiving all the command class from the controller. The ZA1502-7 will go to sleep mode without receiving any Z-Wave command till 10 seconds. It will proceed all the commands after sending the “Wake Up Notification”
Auto Wake Up, Battery Capacity Detection, Explorer Frame & OTA
SmartStart location
SmartStart QR code's location as follows: The DSK label will on the backside of ZA1502-7, Scan the DSK label to access the SmartStart if gateway 's UI supports SmartStart. (Remark: The QR code is for use with Z-Wave SmartStart by using “DSK,” “Device Specific Key,” “PIN,” or “PIN code,” etc.)
For “Inclusion” in (adding to) a network: Put the Z-Wave™ Interface Controller into “inclusion” mode, and following its instruction to add the ZA1502-7 to your controller. To get in the “inclusion” mode, quick press the button of ZA1502-7 5 times for sending the NIF, the Red/Green LED will flash 5 times quickly before the learning process for showing the sensor has not been included. After sending NIF, Z-Wave will send the auto inclusion, the Red/Green LED will flash 1 second after successful inclusion; otherwise, ZA1502-7 will go to sleep after 30 seconds. The red LED will be flashing while the inclusion is proceeding.
Factory reset 2 in 1 Universal Remote
Factory Default Reset:
Quick press the button of ZA1502-7 4 times and hold the button around 5 seconds until the Red LED is on to send the “Device Reset Locally Notification” command and reset to the factory default.
(Remark: This is to be used only in the case of primary controller being inoperable or otherwise unavailable.)
Please note that this is a user manual 2 in 1 Universal Remote from Vision is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have 2 in 1 Universal Remote and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.