4in1 PIR Sensor (ZP3111EU-5) manual for Z-Wave

The following is an overview of the user manual for the Z-Wave product 4in1 PIR Sensor (ZP3111EU-5)from Vision. To view other Z-Wave products and manuals from Vision follow that link.

  1. Overview
  2. Security
  3. Features
  4. Installation instructions


4in1 PIR Sensor
SKU Code
* Includes Motion, Temperature, Humidity, and Light sensor
* 360 degree detection (suitable for ceiling fixture)
* Compact Size: 59*59*41mm
* 2*AAA Battery
* Low Battery Detection
* LED Status Indicator
* 100feet line of sight
Version #
HW: 1 FW: 5.01:10.01 was the version certified
Certification #
Z-Wave Version


As a Z-Wave Plus certified product, 4in1 PIR Sensor supports Z-Wave S2 security. The following security modes are directly supported:


    Vision describes 4in1 PIR Sensor as having the following features:

    • FLiRS capable
    • Supports Network Wide Inclusion
    • Supports Z-Wave Explorer Frames
    • Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via

    Installation instructions

    Factory reset 4in1 PIR Sensor

    Remove cover to trigged tamper switch, LED flash once & send out Alarm Report. Press Program Switch 10 times within 10 seconds, ZP3111 will send the “Device Reset Locally Notification” command and reset to the factory default. (Remark: This is to be used only in the case of primary controller being inoperable or otherwise unavailable.)

    To add the ZP3111 to theZ-Wave network (inclusion), place the Z-Wave primary controller into inclusion mode. Press the Program Switch of ZP3111 for sending the NIF. After sending NIF, Z-Wave will send the auto inclusion, otherwise, ZP3111 will go to sleep after 20 seconds.

    To remove the ZP3111 from the Z-Wave network (exclusion), place the Z-Wave primary controller into “exclusion” mode, and following its instruction to delete the ZP3111 to the controller. Press the Program Switch of ZP3111 once to be excluded.

    Use “Wake Up” command to set up the awaking time (from 10 minutes to 1 week) and send the wake up notification to controller

    Please note that this is a user manual 4in1 PIR Sensor from Vision is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have 4in1 PIR Sensor and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.