The following is an overview of the user manual for the Z-Wave product Arrival Sensor (ZA1501JP-5)from Vision. To view other Z-Wave products and manuals from Vision follow that link.
Overview
Security
As a Z-Wave Plus certified product, Arrival Sensor supports Z-Wave S2 security. The following security modes are directly supported:
- S2 Authenticated
- S2 Unauthenticated
Features
Vision describes Arrival Sensor as having the following features:
- Outdoor Use
- Color
- Firmware updatable via a compatible Z-Wave gateway
- Sensors
- Supported Notification Types
- Battery Quantity
- Battery powered using Lithium Polymer batteries
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
For “Exclusion” from (removing from) a network: Put the Z-Wave™ Interface Controller into “exclusion” mode, and following its instruction to delete the arrival sensor from your controller. Press the Program Switch of arrival sensor to be excluded.
Note: All user and network settings will be cleared and the device reset to factory defaults when the device is excluded.
For “Inclusion” in (adding to) a network: Put the Z-Wave™ Interface Controller into “inclusion” mode, and following its instruction to add the arrival sensor to your controller. To get in the “inclusion” mode, press the Program Switch of arrival sensor for sending the NIF. After sending NIF, Z-Wave will send the auto inclusion; otherwise, arrival sensor will go to sleep after 30 seconds.
Factory reset Arrival Sensor
Factory Default Reset: Long press the program switch up to 10 seconds to send the “Device Reset Locally Notification” command and reset to the factory default.
(Remark: This is to be used only in the case of primary controller being inoperable or otherwise unavailable.)
Wake Up Notification:
Press the program switch, arrival sensor will be “Wake Up Mode” for receiving all the command class from controller. The arrival sensor will go to sleep mode or it will wait 10 seconds then go sleep mode. It will proceed all the commands after sending the “Wake Up Notification”
Auto Wake Up, Battery Capacity Detection, Explorer Frame & OTA
Please note that this is a user manual Arrival Sensor from Vision is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Arrival Sensor and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.