The following is an overview of the user manual for the Z-Wave product CO Detector (ZS6301EU-5)from Vision. To view other Z-Wave products and manuals from Vision follow that link.
Overview
Security
As a Z-Wave Plus certified product, CO Detector supports Z-Wave S2 security. The following security modes are directly supported:
Features
Vision describes CO Detector as having the following features:
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
Factory reset CO Detector
N/A
To leave “Sleep” mode, please press the test switch once, the device will send “Wake Up Notification” after 10 seconds.
For “Exclusion” from (removing from) a net work: Put the Z-Wave™ Interface Controller into “exclusion” mode, and following its instruction to delete the ZS6301-5 from your controller. Press the test switch of ZS6301-5 once to be excluded.
For “Inclusion” in (adding to) a network: Put the Z-Wave™ Interface Controller into “inclusion” mode, and following its instruction to add the ZS6301-5 to your controller. To get in the “inclusion” mode, the distance between detector and controller is suggested to be in one meter. By power on to get included for first time or press the test switch of ZS6301-5 once to be included. After be included, the red LED will go on.
Please note that this is a user manual CO Detector from Vision is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have CO Detector and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.