The following is an overview of the user manual for the Z-Wave product Glass Break Detector (ZB5311US-5)from Vision. To view other Z-Wave products and manuals from Vision follow that link.
Overview
Security
As a Z-Wave Plus certified product, Glass Break Detector supports Z-Wave S2 security. The following security modes are directly supported:
- S2 Authenticated
- S2 Unauthenticated
Features
Vision describes Glass Break Detector as having the following features:
- Firmware updatable via a compatible Z-Wave gateway
- Battery Quantity
- Battery powered using CR123A batteries
- Color
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
SmartStart location
SmartStart QR code's location as follows: The DSK label will on the backside of ZB5311-5, Scan the DSK label to access the SmartStart if gateway 's UI supports SmartStart. (Remark: The QR code is for use with Z-Wave SmartStart by using “DSK,” “Device Specific Key,” “PIN,” or “PIN code,” etc.)
For “Exclusion” from (removing from) a network: Put the Z-Wave™ Interface Controller into “exclusion” mode, and following its instruction to delete the ZB5311-5 from your controller. Press the Program Switch of ZB5311-5 once to be excluded, the Green LED will flash 5 times quickly after successful exclusion.
Note: All user and network settings will be cleared and the device reset to factory defaults when the device is excluded.
For “Inclusion” in (adding to) a network: Put the Z-Wave™ Interface Controller into “inclusion” mode, and following its instruction to add the ZB5311-5 to your controller. To get in the “inclusion” mode, press the Program Switch of ZB5311-5 once for sending the NIF. After sending NIF, Z-Wave will send the auto inclusion; otherwise, ZB5311-5 will go to sleep after 30 seconds. After inclusion successfully, the Green LED will be solid on for 0.5 second.
Factory reset Glass Break Detector
Factory Default Reset: Long press the program switch up to 10 seconds to send the “Device Reset Locally Notification” command and reset to the factory default. The Green LED will flash 5 times quickly after finishing the Factory Default Reset.
(Remark: This is to be used only in the case of primary controller being inoperable or otherwise unavailable.)
Wake Up Notification:
Press the program switch once to send NIF, it takes around 5 seconds to send "Wake Up Notification" for receiving all the command class from controller. The ZB5311-5 will go to sleep mode without receiving any Z-Wave command till 10 seconds.
Please note that this is a user manual Glass Break Detector from Vision is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Glass Break Detector and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.