The following is an overview of the user manual for the Z-Wave product In-wall Two Relay (ZL7435EU-5)from Vision. To view other Z-Wave products and manuals from Vision follow that link.
Overview
* Operating Range: Up to 100 feet line of sight
* Operating Temp.: -15°C~ 60°C (5°F~140°F)
* Operating Voltage: 100VAC~240VAC
* Resistive Load:
550W 110 VAC
1100W 220 VAC
Security
As a Z-Wave Plus certified product, In-wall Two Relay supports Z-Wave S2 security. The following security modes are directly supported:
Features
Vision describes In-wall Two Relay as having the following features:
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
Factory reset In-wall Two Relay
Factory Default Reset: Power off first, press Program Switch and power on till 10 seconds, ZL7435EU-5 will send the “Device Reset Locally Notification” command and reset to the factory default. (Remark: This is to be used only in the case of primary controller being inoperable or otherwise unavailable.)
For “Inclusion” in (adding to) a network: Put the Z-Wave™ Interface Controller into “inclusion” mode, and following its instruction to add the ZL 7435EU-5 to your controller. To get in the “inclusion” mode, the distance between module and controller is suggested to be in one meter.
Press 3 times within 2 seconds or turn on the wall switch 3 times within 2 seconds (or press toggle switch 3 times) to be included.
For “Exclusion” from (removing from) a network: Put the Z-Wave™ Interface Controller into “exclusion” mode, and following its instruction to delete the ZL 7435EU-5 from your controller. Press 3 times within 2 seconds or turn on the wall switch 3 times within 2 seconds (or press toggle switch 3 times) to be excluded.
Please note that this is a user manual In-wall Two Relay from Vision is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have In-wall Two Relay and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.