Categories

Aeotec

Atrim

SmartThings

Z-Wave Products

Motion Detector (with Temperature Sensor) (ZP3102EU-5) manual for Z-Wave

The following is an overview of the user manual for the Z-Wave product Motion Detector (with Temperature Sensor) (ZP3102EU-5)from Vision. To view other Z-Wave products and manuals from Vision follow that link.

  1. Overview
  2. Security
  3. Features
  4. Installation instructions

Overview

Name
Motion Detector (with Temperature Sensor)
SKU Code
ZP3102EU-5
Description
The ZP3102 is a Z-Wave enabled motion detector and temperature sensor. The motion detector has 120 degrees of horizontal visibility and 60 degrees of vertical visibility. The temperature sensor that is built in to the ZP3102 is capable of reporting in both Celsius and Fahrenheit scales, and may be queried for the temperature and it will report it automatically when it detects changes. The sensor is battery operated and includes the ability to report the battery level and will transmit an alert signal if the battery assumes a critically low level. The ZP3102 is future-proofed by also supporting the ability to have its firmware updated over the Z-Wave network.
Version #
02 was the version certified
Certification #
ZC10-14100005
Certified
2014-07-25T13:21:55.054475
Z-Wave Version
6.51.02

Security

As a Z-Wave Plus certified product, Motion Detector (with Temperature Sensor) supports Z-Wave S2 security. The following security modes are directly supported:

    Features

    Vision describes Motion Detector (with Temperature Sensor) as having the following features:

    • FLiRS capable
    • Supports Network Wide Inclusion
    • Supports Z-Wave Explorer Frames
    • Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via

    Installation instructions

    Put the Z-Wave Interface Controller into “exclusion” mode, and following its instruction to delete the ZP3102 to your Z-Wave network. Press the Program Switch of ZP3102 once to be excluded. The LED on the ZP3102 should start to flash.

    Put the Z-Wave Interface Controller into 'inclusion' mode, and follow its instructions to add the ZP3102 to your Z-Wave network. For a successful inclusion, it is suggested to have the sensor and your Z-Wave controller about one meter apart. Press the Program Switch of the ZP3102 (refer to the manual for the location of the program switch) ready the ZP3102 for inclusion into the Z-Wave network. If inclusion does not take place or is unsuccessful within 20 seconds, the ZP3102 will go to sleep; if this happens, simply repeat pressing the program switch to try again.

    Remove the rear cover to wake up the device, or set the wake up interval time from 10 minutes to 1 week. The battery will be drained quickly if you fail to replace the cover after using that method to wake up the device.

    Factory reset Motion Detector (with Temperature Sensor)

    Removing the rear cover to wake up the device. Press Program Switch 10 times within 10 seconds, ZP3102 will go back to factory default. (This is to be used only in the case of the primary controller being inoperable or otherwise unavailable.)

    Please note that this is a user manual Motion Detector (with Temperature Sensor) from Vision is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Motion Detector (with Temperature Sensor) and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.