Outdoor Siren (ZM1621BR-5) manual for Z-Wave

The following is an overview of the user manual for the Z-Wave product Outdoor Siren (ZM1621BR-5)from Vision. To view other Z-Wave products and manuals from Vision follow that link.

1. Overview
2. Security
3. Features
4. Installation instructions

Overview

Security

As a Z-Wave Plus certified product, Outdoor Siren supports Z-Wave S2 security. The following security modes are directly supported:

Features

Vision describes Outdoor Siren as having the following features:

• Supported Notification Types
• FLiRS capable
• Supports Network Wide Inclusion
• Supports Z-Wave Explorer Frames
• Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via

Installation instructions

Factory reset Outdoor Siren

ZM 1621 will reset to factory default when the device has been excluded.
(Please use this procedure only in the event that your network primary controllers is missing or otherwise inoperable!)

removing the back cover of the ZM1621 to get into “Awake” mode

1. Support OTA firmware update from controller
2. Support Explorer Frame function

For “Exclusion” in (removing from) a network: Put the Z-Wave™ Interface Controller into “exclusion” mode, and following its instruction to remove the ZM 1621 from your controller. ZM1621-5 will send NWE if the exclusion could not be done successfully.
Note:
a. LED light will flash continuously in Exclusion condition.
b. All user and network settings will be cleared and the device reset to factory defaults when the device is excluded.

For “Inclusion” in (adding to) a network: Put the Z-Wave™ Interface Controller into “inclusion” mode, and following its instruction to add the ZM 1621 to your controller. To get in the “inclusion” mode, get magnet of the bracket to touch the reed switch on the ZM1621 and separate at once to be included. After setting, the LED Light should go off, if not, please try again. (After sending one time’s Z-Wave NIF and not be included then it will send NWI for auto inclusion. The LED light will flash again if the siren has not been included or the LED light will go off after inclusion.)

Please note that this is a user manual Outdoor Siren from Vision is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Outdoor Siren and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.