The following is an overview of the user manual for the Z-Wave product Power Monitor (ZL7261US-5)from Vision. To view other Z-Wave products and manuals from Vision follow that link.
Overview
* Plug Connection
* Auto Inclusion
* 3 Steps LED Indication: Green /Orange/ Red
* Max. Current: 15A
* Input Voltage: 90 ~ 230 VAC
* Power Monitor Range: Watt: 0.1W ~2200W@220VAC
Security
As a Z-Wave Plus certified product, Power Monitor supports Z-Wave S2 security. The following security modes are directly supported:
Features
Vision describes Power Monitor as having the following features:
- Color
- Electric Load Type
- Firmware updatable via a compatible Z-Wave gateway
- Switch Load Capacity Current
- Supported Meter Type
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
For “Inclusion” in (adding to) a network: Put the Z-Wave TM Interface Controller into “inclusion” mode, and following its instruction to add the ZL7261 into your controller. To get in the “Inclusion” mode, by power up to get included for first time, or press the Program switch 3 times within 2 seconds to be included.
For “Exclusion” from (removing from) a network: Set up the Z-Wave TM Interface Controller into “exclusion” mode, and following its instruction to delete the ZL7261 from your controller. Press the Program Switch 3 times within 2 seconds to be excluded.
Factory reset Power Monitor
Reset: Press the Program Switch then power on (plug-in) and hold for 5 seconds before release the switch. Only use this procedure when the primary controller is lost or otherwise inoperable.
Please note that this is a user manual Power Monitor from Vision is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Power Monitor and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.