The following is an overview of the user manual for the Z-Wave product Power Switch (ZL7434EU-5)from Vision. To view other Z-Wave products and manuals from Vision follow that link.
Overview
* Size: 3.95 x 5.0 x 1.9 cm
* Operating Range: Up to 100 feet line of sight
* Operating Temp.: -10°C~ 60°C (14°F~140°F)
* Operating Voltage: 90 VAC~240 VAC, 50/60 Hz
* Max. Loading: 15A
Security
As a Z-Wave Plus certified product, Power Switch supports Z-Wave S2 security. The following security modes are directly supported:
Features
Vision describes Power Switch as having the following features:
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
Put the Z-Wave™ Interface Controller into “inclusion” mode, and following its instruction to add the ZL 7434-5 to your controller. To get in the “inclusion” mode, the distance between module and controller is suggested to be in one meter. Press 3 times program switch within 2 seconds or turn on the wall switch 3 times within 2 seconds (or press toggle switch 3 times) to be included.
Put the Z-Wave™ Interface Controller into “exclusion” mode, and following its instruction to delete the ZL 7434-5 from your controller.
Press 3 times program switch within 2 seconds or turn on the wall switch 3 times within 2 seconds (or press toggle switch 3 times) to be excluded.
Factory reset Power Switch
Power off first, press Program Switch and power on, ZL7434-5 will send the “Device Reset Locally Notification” command and reset to the factory default. (Remark: This is to be used only in the case of primary controller being inoperable or otherwise unavailable.)
Please note that this is a user manual Power Switch from Vision is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Power Switch and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.