The following is an overview of the user manual for the Z-Wave product U-Bell (ZM1611JP-5)from Vision. To view other Z-Wave products and manuals from Vision follow that link.
Overview
Security
As a Z-Wave Plus certified product, U-Bell supports Z-Wave S2 security. The following security modes are directly supported:
- S2 Authenticated
- S2 Unauthenticated
Features
Vision describes U-Bell as having the following features:
- Z-Wave Scene Type
- Battery Quantity
- Battery powered using AA batteries
- Firmware updatable via a compatible Z-Wave gateway
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
For “Inclusion” in (adding to) a network: Put the Z-Wave™ Interface Controller into “inclusion” mode, and following its instruction to add the ZM1611-5 to your controller. To get in the “inclusion” mode, press and hold the program switch of ZM1611-5 for 3 seconds at least & release to be included. After setting, the LED should go off, if not, please try again. (After sending one time’s Z-Wave NIF and not be included then it will send 4 times NWI in every 30 seconds for auto inclusion. The LED will flash again if the U-Bell has not been included or the LED will go off after inclusion.)
For “Exclusion” from (removing from) a network: Set up the Z-Wave™ Interface Controller into “exclusion” mode, and following its instruction to remove the ZM1611-5 from your controller. Press and hold the program switch of ZM1611-5 for 3 seconds at least & release to be excluded. The LED will flash again after exclusion
Factory reset U-Bell
For ""Reset"": Press and hold the Program Switch for 5 seconds “at least”, power on until the LED turns on then release the switch, U-Bell will send Command Class Device Reset Locally for Reset Process. (Remark: This is to be used only in the case of primary controller being inoperable or otherwise unavailable.)
Please note that this is a user manual U-Bell from Vision is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have U-Bell and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.