The following is an overview of the user manual for the Z-Wave product Wireless Shock Sensor (ZS5101US-5)from Vision. To view other Z-Wave products and manuals from Vision follow that link.
Overview
* Non-Touch Vibration Design for Longer Lifetime
* Adjustable Sensitivity
* Tamper Switch
* Battery Detection
* LED Status Indicator
* Battery Life: 2 Years
Security
As a Z-Wave Plus certified product, Wireless Shock Sensor supports Z-Wave S2 security. The following security modes are directly supported:
Features
Vision describes Wireless Shock Sensor as having the following features:
- Color
- Battery Quantity
- Battery powered using CR123A batteries
- Sensors
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
Put the Z-Wave™ Interface Controller into “inclusion” mode, and following its instruction to add the ZS 5101-5 to your controller. To get in the “inclusion” mode, please press the program switch of ZS 5101-5 for 1 second at least to be included. The LED on the ZS 5101-5 should go off, if not, please try again.
Factory reset Wireless Shock Sensor
*Push the Tamper switch then power on (put in the battery) & hold the Tamper switch for 5 seconds, ZD5101-5 will send the “Device Reset Locally Notification” command and reset to the factory default, LED will solid on, need to take off the battery and re-put in the battery to complete the function.
*Please use this procedure only in the event that the network primary controller is missing or otherwise inoperable.
Put the Z-Wave™ Interface Controller into “exclusion” mode, and following its instruction to delete the ZS 5101-5 from your controller. Press the program switch of ZS 5101-5 for 1 second at least to be excluded.
Use “Wake Up” command to set up the awaking time and send the wake up notification to controller. User can use command to change the auto wake up from 500 seconds to 1 week, Interval increment is 250 seconds. (Default: 6 hours)
*Use “Battery Get” command to have the battery capacity back in %
Please note that this is a user manual Wireless Shock Sensor from Vision is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Wireless Shock Sensor and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.