Wireless Siren (ZM1602US-5) manual for Z-Wave

The following is an overview of the user manual for the Z-Wave product Wireless Siren (ZM1602US-5)from Vision. To view other Z-Wave products and manuals from Vision follow that link.

  1. Overview
  2. Security
  3. Features
  4. Installation instructions


Wireless Siren
SKU Code

*Loud audible alarm>105dB@1 meter
*LED strobe lighting
*Low battery detection
*Siren for Battery Back-Up
*100ft line of sight
*LED Status Indicator
*Operating temp: -15oC~60oC
*Working Voltage: 6V
*Dimensions: 116*77*40mm
Version #
HW: 1 FW: 15.10:05.01 was the version certified
Certification #
Z-Wave Version


As a Z-Wave Plus certified product, Wireless Siren supports Z-Wave S2 security. The following security modes are directly supported:


    Vision describes Wireless Siren as having the following features:

    • Color
    • Supported Notification Types
    • FLiRS capable
    • Supports Network Wide Inclusion
    • Supports Z-Wave Explorer Frames
    • Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via

    Installation instructions

    Put the Z-Wave™ Interface Controller into “inclusion” mode, and following its instruction to add the ZM 1602 to your controller. To get in the “inclusion” mode, the distance between siren and controller is suggested to be in one meter. Open the bracket and press the program switch of ZM 1602 for 1 second at least & release to be included. After setting, the LED Setting Lighting should go off,

    Set up the Z-Wave™ Interface Controller into “exclusion” mode, and following its instruction to delete the ZM 1602 from your controller. Press the Tamper Switch of ZM 1602 for 1 second at least & release to be excluded.

    Factory reset Wireless Siren

    This device can’t be reset manually. It is reset to factory defaults when it is excluded. Please use this procedure only when the network primary controller is missing or otherwise inoperable.

    removing the back cover of the ZM1602 to get into “Awake” mode,

    1. Support OTA firmware update from controller
    2. Support Explorer Frame function

    Please note that this is a user manual Wireless Siren from Vision is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Wireless Siren and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.