The following is an overview of the user manual for the Z-Wave product Z-Wave Gateway (ZA1011EU-5)from Vision. To view other Z-Wave products and manuals from Vision follow that link.
Overview
Security
As a Z-Wave Plus certified product, Z-Wave Gateway supports Z-Wave S2 security. The following security modes are directly supported:
- S2 Access Control
- S2 Authenticated
- S2 Unauthenticated
Features
Vision describes Z-Wave Gateway as having the following features:
- Outdoor Use
- IP (Ingress Protection) Rated
- Controller Supports Multiple Networks
- Gateway Has Preferred Partners
- Controller Supports Multiple Z-Wave Interfaces
- Firmware updatable via a compatible Z-Wave gateway
- Communications Protocol
- Color
- Switch Load Capacity Volt-Ampere
- Z-Wave Scene Type
- Communications Connections
- Switch Load Capacity Current
- Supported Notification Types
- Sensors
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
1) Follow the manufacturer’s instructions of the other controller to enable it into Add mode.
2) Click “Learn Mode” button. If it is a S2 Controller, the DSK of the Gateway will appear. Please key in the DSK to the other Controller UI when prompted.
3) When completed, the UI will show the existing Controller and device(s) in the network.
Factory reset Z-Wave Gateway
1) Select “Reset Locally” button.
2) Confirm the dialog. This will perform a factory reset to the Gateway.
If this controller is the primary controller for your network, resetting it will result in the nodes in your network being orphaned and it will be necessary after the reset to exclude and re-include all of the nodes in the network. If this controller is being used as a secondary controller in the network, use this procedure to reset this controller only in the event that the network primary controller is missing or otherwise inoperable.
Please note that this is a user manual Z-Wave Gateway from Vision is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Z-Wave Gateway and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.