The following is an overview of the user manual for the Z-Wave product Smart Hub (CP04)from Vivint. To view other Z-Wave products and manuals from vivint follow that link.
Overview
Security
As a Z-Wave Plus certified product, Smart Hub supports Z-Wave S2 security. The following security modes are directly supported:
- S2 Access Control
- S2 Authenticated
- S2 Unauthenticated
Features
vivint describes Smart Hub as having the following features:
- Sensors
- Supported Notification Types
- Firmware updatable via a compatible Z-Wave gateway
- Communications Connections
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
To remove a Z-Wave device to the panel network — as with all sensors and peripheral devices — follow the detailed installation instructions included with that particular device.
To access Z-Wave settings from the control panel, go to:
Menu > Software Version > Installer Toolbox > Smart Home Devices > Z-Wave
To add a Z-Wave device to the panel network — as with all sensors and peripheral devices — follow the detailed installation instructions included with that particular device.
To access Z-Wave settings from the control panel, go to:
Menu > Software Version > Installer Toolbox > Smart Home Devices > Z-Wave
Factory reset Smart Hub
The SmartHub’s Z-Wave network can be reset to a default state, removing all Z-Wave devices in the process. Please use this procedure only when the network primary controller is missing or otherwise inoperable. To do this, follow these instructions from the settings tab:
5.2
1. 2. 3. 4. 5. 6.
On the “Support” page, touch “Software version” Enter the default installer PIN code (2203)
Select “Smart Home devices”
Select “Z-Wave”
Select “Reset controller”
Follow the on-screen instructions to complete the operation.
Please note that this is a user manual Smart Hub from Vivint is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Smart Hub and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.