The following is an overview of the user manual for the Z-Wave product Walmart WiFi Bridge (WMBR-1)from Walmart, Inc. To view other Z-Wave products and manuals from Walmart follow that link.
Overview
Security
As a Z-Wave Plus certified product, Walmart WiFi Bridge supports Z-Wave S2 security. The following security modes are directly supported:
- S2 Access Control
- S2 Authenticated
- S2 Unauthenticated
Features
Walmart describes Walmart WiFi Bridge as having the following features:
- Gateway Has Preferred Partners
- Color
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
1. From the home screen, navigate to the Settings page by pressing the (insert gear icon)
2. Select the About page
3. Select ‘Advanced Z-Wave Utilities’
4. Select ‘Add device’
5. Refer to the manufacturer’s instruction for inclusion using the DSK (device specific key). A user may attempt to use classic inclusion by entering `00000` as the DSK.
6. The app will indicate when device inclusion is successful
EXCLUSION
1. From the home screen, navigate to the Settings page by pressing the (insert gear icon)
2. Select the About page
3. Select ‘Advanced Z-Wave Utilities’
4. Select ‘Exclude garage opener’ to put the bridge in Exclusion Mode. Refer to the manufacturer’s instruction for exclusion.
5. The app will indicate when device exclusion is successful.
Factory reset Walmart WiFi Bridge
If this controller is the primary controller for your network, resetting it will result in the nodes in your network being orphaned and it will be necessary after the reset to exclude and re-include all of the nodes in the network. If this controller is being used as a secondary controller in the network, use this procedure to reset this controller only in the event that the network primary controller is missing or otherwise inoperable.
To factory reset the WiFi Bridge, which will also factory reset and delete all Z-Wave network information, press and hold the button on the back of the bridge for 20 seconds.
SmartStart location
SmartStart QR code's location as follows: The WiFi Bridge’s DSK (Device Security Key) is located in the WiFi bridge details page on the secure APP (TLS) and can be accessed by going to Settings > Garage Door Controller Device > WiFi bridge > Bridge details.
Please note that this is a user manual Walmart WiFi Bridge from Walmart, Inc is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Walmart WiFi Bridge and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.