The following is an overview of the user manual for the Z-Wave product Home Gateway 2 Plus (WBH-HG2+EU)from WeBeHome. To view other Z-Wave products and manuals from WeBeHome follow that link.
Overview
A web portal is used to maintain the system and get access to advanced functions. The WeBeHome Control app is used to view and control the home.
It is possible to add multiple Locations with multiple Gateways. The role based user permission system give possibilities to invite family, friends and neighbors to get a secure solution.
The web and app are available in English, French and Swedish.
Security
As a Z-Wave Plus certified product, Home Gateway 2 Plus supports Z-Wave S2 security. The following security modes are directly supported:
Features
WeBeHome describes Home Gateway 2 Plus as having the following features:
- Firmware updatable via a compatible Z-Wave gateway
- Color
- Communications Connections
- Sensors
- Supported Notification Types
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
In the WeBeHome portal:
- Open the accessory configuration page
- Press the ""Remove"" button
In the WeBeHome portal:
- Press the ""Add Z-Wave accessory"" button
- Select the accessory from the list or select ""Generic Z-Wave accessory""
In the WeBeHome portal:
- Open the Z-Wave module configuration page
- Press the ""Start"" button on the section ""Add this Home Gateway to an existing Z-Wave network (Start Network Wide Learn Mode)
Factory reset Home Gateway 2 Plus
In the WeBeHome portal:
- Open the Z-Wave module configuration page
- Press the ""Start"" button on the section ""Reset this Home Gateway Z-Wave network to default settings""
Notice:
It is recommended to use Reset only when the primary controller is missing or inoperable. If this Home Gateway is the primary controller for your Z-Wave network a Reset will make all your Z-Wave accessories beeing orphan. After a Reset it is necessary to exclude (or reset) all accessories and then re-include them.
If this Home Gateway is used as a secondary controller, use this function to make it leave the Z-Wave network.
Please note that this is a user manual Home Gateway 2 Plus from WeBeHome is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Home Gateway 2 Plus and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.