The following is an overview of the user manual for the Z-Wave product 10 Button Z-Wave Plus v2 Deadbolt (GED1800)from Weiser. To view other Z-Wave products and manuals from Weiser follow that link.
Overview
Security
As a Z-Wave Plus certified product, 10 Button Z-Wave Plus v2 Deadbolt supports Z-Wave S2 security. The following security modes are directly supported:
- S2 Access Control
Features
Weiser describes 10 Button Z-Wave Plus v2 Deadbolt as having the following features:
- Battery Quantity
- Battery powered using batteries
- Door Lock Type
- Firmware updatable via a compatible Z-Wave gateway
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
Press button "A" one time.
The lock is a sleepy device and is always in listening mode.
SmartStart location
SmartStart QR code's location as follows: On the product interior chassis.
Press button "A" on the lock interior one time.
For enhanced security, a MasterCode may be used in order to protect local user code maintenance, as well as other configuration settings.
Factory reset 10 Button Z-Wave Plus v2 Deadbolt
1. Remove battery pack.
2. Press and HOLD "Program"
button while reinserting the
battery pack.
Keep holding the button
for 30 seconds until
the lock beeps and the
status LED flashes red.
Please note that this is a user manual 10 Button Z-Wave Plus v2 Deadbolt from Weiser is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have 10 Button Z-Wave Plus v2 Deadbolt and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.