The following is an overview of the user manual for the Z-Wave product SmartCode 5 Touchpad Electronic Lever (GED1455)from Weiser. To view other Z-Wave products and manuals from Weiser follow that link.
Overview
Backlit keypad with One touch locking
30 user codes
Auto re-lock 30 seconds after unlocking
Full 128-bit encryption security
Drill and pick resistant backup keyway
SmartKey: Re-key the lock in seconds
Security
As a Z-Wave Plus certified product, SmartCode 5 Touchpad Electronic Lever supports Z-Wave S2 security. The following security modes are directly supported:
Features
Weiser describes SmartCode 5 Touchpad Electronic Lever as having the following features:
- Firmware updatable via a compatible Z-Wave gateway
- Supported Notification Types
- Battery Quantity
- Battery powered using AA batteries
- Communications Protocol
- Door Lock Type
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
Even though the lock is sleeping, all buttons are active and can be used to initiate any lock activity.
For the RF side, it will wake up every 1 second to check if there are any requests from your smart home controller.
Follow your smart home system’s instructions to remove the lock from the network. When prompted by the system, press button A” on the lock interior once. The red LED will illuminate when the lock enters Remove mode.
Initiate the process to add the lock to your system at your smart home controller.
When prompted by your smart home system to add the lock, press button “A” on the lock interior one time. The red LED will illuminate when the lock enters Add Mode.
Please allow time for the controller to add the lock to your system.
Factory reset SmartCode 5 Touchpad Electronic Lever
A factory reset will delete all user codes associated with the lock and will remove itself from your smart home system.
Please only perform a factory reset when the primary controller is missing or inoperable.
To perform a factory reset, please perform the following:
1. Remove the battery pack
2. Press and HOLD the Program button while reinserting the battery pack.
3. Keep holding the button for 30 seconds until the lock beeps and the status LED flashes red.
4. Press the Program button once more. The status LED will flash green and red several times.
5. After a few seconds, the lock will initiate the door handing process.
Please note that this is a user manual SmartCode 5 Touchpad Electronic Lever from Weiser is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have SmartCode 5 Touchpad Electronic Lever and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.