The following is an overview of the user manual for the Z-Wave product Alfred (1)from wibutler. To view other Z-Wave products and manuals from wibutler follow that link.
Overview
Security
As a Z-Wave Plus certified product, Alfred supports Z-Wave S2 security. The following security modes are directly supported:
Features
wibutler describes Alfred as having the following features:
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
Start the mobile wibutler app and connect to your wibutler. Open the Z-Wave Controller device from the device list and select the menu entry “Add Device” on the “Control Page”. Now, the controller is in inclusion mode.
Start the mobile wibutler app and connect to your wibutler. Open the Z-Wave Controller device from the device list and select the menu entry “Remove Device” on the “Control Page”. Now, the controller is in exclusion mode.
Start the mobile wibutler app and connect to your wibutler. Open the Z-Wave Controller device from the device list and select the menu entry “Learn Mode” on the “Control Page”. Now, the controller is in learn mode.
Factory reset Alfred
Start the mobile wibutler app and connect to your wibutler. Open the Z-Wave Controller device from the device list and select the menu entry “Reset Controller” on the “Control Page”.
n/a
n/a
Please note that this is a user manual Alfred from wibutler is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Alfred and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.