The following is an overview of the user manual for the Z-Wave product Energy Driven Switch Version S (WPM1.04C)from Widom. To view other Z-Wave products and manuals from widom follow that link.
Overview
The only device suited for use with all types of Z-Wave controller, and capable of implementing an active energy-saving management policy defined by the user according to his energy consumption, or to the amount of energy produced by his solar power system. It automatically connects and disconnects a specific load if the threshold limit is exceeded, or “supplies” the required power, momentarily excluding non-priority loads.
Main Feature:
• Active Energy-saving Management
• Control and monitoring of usage
• Control and monitoring of production and net metering
• Monitoring of all network parameters (Power, Energy, Voltage, Current, Power Factor)
• Provides bidirectional measurements for Power and Energy (produced/consumed).
• Management and prevention of electrical faults
• Intelligent Opening/Closing of the Relay
• Control of heavy loads
• Software Update
• Extremely low energy usage
Security
As a Z-Wave Plus certified product, Energy Driven Switch Version S supports Z-Wave S2 security. The following security modes are directly supported:
Features
widom describes Energy Driven Switch Version S as having the following features:
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
1. Put your system controller into inclusion mode by following the instructions provided by your controller manufacturer.
2. Press the push button (B) located on the top of the device once.""
1. Put your system controller into exclusion mode by following the instructions provided by your controller manufacturer.
2. Press the push button (B) located on the top of the device three time.""
Factory reset Energy Driven Switch Version S
Press the push button (B) located on the top of the device six consecutive times within one minute from system start-up. Please use this procedure only in the event that the primary controller is missing or otherwise inoperable.
Before invoke the firmware update from the controller press the push button (B) located on the top of the device four consecutive times.
Please note that this is a user manual Energy Driven Switch Version S from Widom is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Energy Driven Switch Version S and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.