The following is an overview of the user manual for the Z-Wave product Hub (PWHUB-WH01)from Wink. To view other Z-Wave products and manuals from Wink follow that link.
Overview
Security
As a Z-Wave Plus certified product, Hub supports Z-Wave S2 security. The following security modes are directly supported:
Features
Wink describes Hub as having the following features:
- Communications Protocol
- Firmware updatable via a compatible Z-Wave gateway
- Color
- Gateway Has Preferred Partners
- Supported Notification Types
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
Factory reset Hub
The Hub does not have a master factory reset function that will reset all radios. However, it does support a reset for Z-Wave products. The Hubs Z-Wave controller is reset using the Z-Wave Controls interface located under the Hub's settings menu. Within the Z-Wave Controls interface is a ""Reset Z-Wave"" button which will remove all nodes and reset the Z-Wave radio.
Including a product into the Wink Hub is done using the Wink mobile app (iOS or Android). After installing the app and creating an account, the app allows you to select from a list of Wink compatible products. Among these products User's can find Wink specific and generic Z-Wave devices. After selecting a device the Wink app will provide step by step instructions explaining how to include the device. At the appropriate point in the sequence, the app will also place the Hub into inclusion mode.
An alternate option is to use the Z-Wave Controls interface located under the Hub's settings menu. Within the Z-Wave Controls interface is a ""Inclusion Mode"" button which will manually place the Hub into inclusion mode.
The Hub is placed into learn mode using the Z-Wave Controls interface located under the Hub's settings menu. Within the Z-Wave Controls interface is a ""Learning Mode"" button which will manually place the Hub into learn mode.
Excluding a product from the Wink Hub is done using the Wink mobile app (iOS or Android). After including a device it will show up in the controllable products list. Navigating to the device settings will expose a ""Remove"" button that is used to begin the exclusion sequence. Depending on the device the remove button may launch step by step instructions explaining how to exclude the device. At the appropriate point in the sequence, the app will also place the HUB into exclusion mode.
An alternate option is to use the Z-Wave Controls interface located under the HUB's settings menu. Within the Z-Wave Controls interface is a ""Exclusion Mode"" button which will manually place the HUB into exclusion mode.
Please note that this is a user manual Hub from Wink is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Hub and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.