The following is an overview of the user manual for the Z-Wave product Motion Sensor (Wink Motion Sensor)from Wink. To view other Z-Wave products and manuals from Wink follow that link.
Overview
This sensor has flexible mounting options, convenient for multi surface installation on wall, ceiling, shelf or tabletop. The sensor body design with magnetic cradle and angled facet offers easy line-of-sight perspective of the area you wish to monitor, with an extra-wide 110° coverage area, and uses a spherical magnet to hold the sensor body in place, so that it can point in any direction.
The Wink Motion Sensor offers an extra-long z-wave wireless range of up to 150 feet, and requires a Wink Hub or other Z-Wave Plus certified hub for operation. The Motion Sensor comes with a CR123A 3.0V battery and has a three-year battery life, and will send an alert to your smartphone when the device has low battery.
· Z-Wave Plus Certified
· Requires a Z-Wave Plus Certified Hub to operate
· Works with all Z-Wave Plus compatible networks
· Flexible Mounting Options
· 110° Extra-Wide Coverage Area
· Up to 150 feet range
· Three-Year Battery Life (CR123A Battery included)
· Low Battery Indication
· Measurements in millimeters: 45 x 45 x 56.2 mm (combined depth of mount and sensor)
Security
As a Z-Wave Plus certified product, Motion Sensor supports Z-Wave S2 security. The following security modes are directly supported:
Features
Wink describes Motion Sensor as having the following features:
- Battery powered using CR123A batteries
- Battery Quantity
- Sensors
- Color
- Supported Notification Types
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
Follow the instructions for your Z-Wave certified Controller to enter inclusion mode.
When prompted by the Controller:
1. For proper inclusion, bring the Motion Detector within range of your Controller.
2. Pull the tab on the side of the sensor to power on, or remove then re-install the batteries.
The LED indicator will flash five times indicating inclusion.
Follow the instructions for your Z-Wave certified Controller to enter exclusion mode. When prompted by the Controller:
1. Remove the cover of the Motion Detector and be sure it is powered on.
2. Press the Connect Button on the bottom of the device quickly 3 times in a row.
The LED Indicator will flash five times indicating exclusion/disconnection.
Factory reset Motion Sensor
To disconnect from the Z-Wave Network and restore factory default settings:
1. Remove the cover of the Motion Detector and be sure it is powered on.
2. Hold the Connect Button for 10 seconds until the LED indicator blinks once, then release the button.
Only do this if the controller is disconnected or otherwise unreachable!
Because the Motion Detector is a battery powered device, it wakes up on regular intervals to give battery and other status updates to the controller, as well as to accept configuration settings from the controller. This helps to extend the battery life. The device can be forced to wake up to submit these reports or accept new settings immediately by simply pressing and holding the BUTTON for two seconds. The LED INDICATOR will flash once indicating successful wake up.
Please note that this is a user manual Motion Sensor from Wink is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Motion Sensor and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.