The following is an overview of the user manual for the Z-Wave product Gateway (WK-0001)from WINKA SYSIT. To view other Z-Wave products and manuals from Winka Sysit follow that link.
Overview
Security
As a Z-Wave Plus certified product, Gateway supports Z-Wave S2 security. The following security modes are directly supported:
Features
Winka Sysit describes Gateway as having the following features:
- Neutral Wire Required
- Sensors
- Communications Protocol
- Supported Meter Type
- Firmware updatable via a compatible Z-Wave gateway
- Gateway Has Preferred Partners
- Switch Load Capacity Current
- Supported Notification Types
- Color
- Communications Connections
- Switch Type
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
The user clicks the ""Include Device"" menu, and it will pop up a 60s countdown including device prompt box. At the same time, the button on the device being included is pressed down to three (in 1.5s, press three buttons) or other way to let device to start learning mode. It displays ""Inclusion Success"", indicating that the device will be displayed in the interface when the device is included
The user first clicks on the ""Exclude Device"" menu, and it will pop up a 60s countdown exclude device prompt box , at the same time, the buttons on the included device are quickly pressed three (with three buttons in 1.5s) or other way to let device to start learning mode, then it will showing ""Exclusion Success"" when device is exclusion from network success
Factory reset Gateway
When the user clicks the icon in the APP homepage interface at top right corner, The user clicks ""Setting"" again and enters the setting interface,The user clicks the ""Z-WAVE Controller Reset"" menu in the interface as shown above and the ""Warning Dialog"" prompt interface pops up , after clicking ""OK"" to confirm the reset. (to use the reset procedure only when the primary controller is missing or inoperable.)
The user clicks ""Z-WAVE Controller Learning Mode"" on the APP , the ""Learning Model"" prompt box will be popped , then click ""OK"" to show ""Being processed...""The ""Learn mode start"" is displayed in APP indicating that the learning mode is successfully opened
Please note that this is a user manual Gateway from WINKA SYSIT is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Gateway and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.