The following is an overview of the user manual for the Z-Wave product Energy Meter (WTR-1110-011)from Winytechnology. To view other Z-Wave products and manuals from Winytechnology follow that link.
Overview
Security
As a Z-Wave Plus certified product, Energy Meter supports Z-Wave S2 security. The following security modes are directly supported:
Features
Winytechnology describes Energy Meter as having the following features:
- Switch Load Capacity Watts
- Firmware updatable via a compatible Z-Wave gateway
- Switch Load Capacity Current
- Color
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
A. Confirm that a device must be wireless access to Z-Wave network. (Fn Display: Green LED OFF)
B. Set “NW Inclusion” or “Node Add” by controller.
C. Press Fn switch 3 times in a row to include device to Z-Wave network. (Fn Display: Green LED blinking)
Press Fn switch 3 times in a row to cancel during including Z-Wave network.
(Fn Display: Green LED OFF)
D. Confirm that a device is including to Z-Wave network. (Fn Display: Green LED blinking)
Factory reset Energy Meter
Use this procedure only in the event that the network primary controller is missing or otherwise inoperable.
Press Fn switch over 10~15 sec to initialize connecting network information.
A. Confirm that a device is including to Z-Wave network. (Fn Display: Green LED blinking)
B. Set “Node remove” by controller.
C. Press Fn switch 3 times in a row to cancel during including Z-Wave network.
(Fn Display: Red LED blinking)
If the controller is not on “Node remove” status, device will automatically cancel “Exclusion”.
(Fn Display: Green LED ON)
D. Confirm that it remove the device from Z-Wave network. (Fn Display Green LED - OFF)
Please note that this is a user manual Energy Meter from Winytechnology is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Energy Meter and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.