The following is an overview of the user manual for the Z-Wave product Smart Energy Multi tap (WTR-1221-111)from Winytechnology. To view other Z-Wave products and manuals from Winytechnology follow that link.
Overview
Security
As a Z-Wave Plus certified product, Smart Energy Multi tap supports Z-Wave S2 security. The following security modes are directly supported:
Features
Winytechnology describes Smart Energy Multi tap as having the following features:
- Switch Load Capacity Current
- Switch Load Capacity Volt-Ampere
- Switch Load Capacity Watts
- Supported Meter Type
- Switch Type
- Color
- Firmware updatable via a compatible Z-Wave gateway
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
Press Fn switch 3 times in a row to include the device to Z-Wave network.
Press Fn switch 3 times in a row again to cancel the inclusion of the device on Z-Wave network.
Factory reset Smart Energy Multi tap
Use this procedure only in the event that the network primary controller is missing or otherwise inoperable. Press Fn switch over 10~15 sec to initialize connecting network information.
Please note that this is a user manual Smart Energy Multi tap from Winytechnology is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Smart Energy Multi tap and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.