The following is an overview of the user manual for the Z-Wave product Wall Switch (WTR-1210-11)from Winytechnology. To view other Z-Wave products and manuals from Winytechnology follow that link.
Overview
Adds local and Z-Wave On/Off control to a wired light or appliance and can replace a traditional On/Off switch.
Security
As a Z-Wave Plus certified product, Wall Switch supports Z-Wave S2 security. The following security modes are directly supported:
Features
Winytechnology describes Wall Switch as having the following features:
- Switch Load Capacity Volt-Ampere
- Switch Load Capacity Current
- Switch Load Capacity Watts
- Neutral Wire Required
- Firmware updatable via a compatible Z-Wave gateway
- Color
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
A. Confirm that a device must be wireless access to Z-Wave network. (Fn Display: Green LED OFF)
B. Set “NW Inclusion” or “Node Add” by controller.
C. Press Fn switch 3 times in a row to include the device to Z-Wave network. (Fn Display: Green LED blinking)
D. Confirm that a device is included on Z-Wave network. (Fn Display: Green LED blinking)
A. Confirm that a device is included on Z-Wave network. (Fn Display: Green LED blinking)
B. Set “Node remove” by controller.
C. Press Fn switch 3 times in a row to cancel the incluion on Z-Wave network.
(Fn Display: Red LED blinking)
If the controller is not on “Node remove” status, device will automatically cancel “Exclusion”.
(Fn Display: Green LED ON)
D. Confirm that it remove the device from Z-Wave network. (Fn Display Green LED - OFF)
Factory reset Wall Switch
Use this procedure only in the event that the network primary controller is missing or otherwise inoperable.
Press Fn switch over 10~15 sec to initialize connecting network information.
Please note that this is a user manual Wall Switch from Winytechnology is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Wall Switch and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.