The following is an overview of the user manual for the Z-Wave product Wtr-1000-11 (03110101)from Winytechnology. To view other Z-Wave products and manuals from Winytechnology follow that link.
Overview
* Extends range of Z-WAVE mesh network
* Easy to install
* The standby power is less than 2W.
Security
As a Z-Wave Plus certified product, Wtr-1000-11 supports Z-Wave S2 security. The following security modes are directly supported:
Features
Winytechnology describes Wtr-1000-11 as having the following features:
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
A. Press Button switch 3 times in a row to link device to Z-Wave network or remove device from Z-Wave network.
B. Press Button switch 3 times in a row again to cancel to link device to Z-Wave network.
A. Acknowledge of Green LED lightning.
B. Press Button switch 3 times in a row to link device to Z-Wave network or remove device from Z-Wave network.
Factory reset Wtr-1000-11
A. Press Fn switch over 2minutes to initialize connecting network information.
Use this procedure only in the event that the network primary controller is missing or otherwise inoperable.
Please note that this is a user manual Wtr-1000-11 from Winytechnology is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Wtr-1000-11 and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.