Categories

Aeotec

Atrim

SmartThings

Z-Wave Products

Assure Lever Touchscreen with Z-Wave Plus (YRL226-ZW2) manual for Z-Wave

The following is an overview of the user manual for the Z-Wave product Assure Lever Touchscreen with Z-Wave Plus (YRL226-ZW2)from Yale Locks & Hardware. To view other Z-Wave products and manuals from Yale follow that link.

  1. Overview
  2. Security
  3. Features
  4. Installation instructions

Overview

Name
Assure Lever Touchscreen with Z-Wave Plus
SKU Code
YRL226-ZW2
Description
Replace your existing lever or knob with the Assure Lever, a touchscreen lever lock, and enjoy the convenience of unlocking and locking your door using the backlit touchscreen keypad; you'll never have to carry around your keys again. Create unique entry codes for friends and family and remove codes whenever you need to. Great for side entry doors, garage entry, basement doors, home offices - any door with a single hole prep. The lock is Grade 2 certified and backed Yale, one of the world's best known brands in the lock industry that's been securing homes since 1840, ensuring that your home and family is always safe. The Assure Lever features Z-Wave technology and seamlessly integrates into compatible home automation and alarm systems. When added to most Z-Wave automation systems, lock and unlock your door, create pin codes, view access history and receive notifications from anywhere. Easy to install and even easier to use! *Features may vary based on Z-Wave controller.
Version #
HW: 255 FW: 1.78:28.00 was the version certified
Certification #
ZC10-18106272
Certified
2018-10-16T18:44:40.140642
Z-Wave Version
6.51.07

Security

As a Z-Wave Plus certified product, Assure Lever Touchscreen with Z-Wave Plus supports Z-Wave S2 security. The following security modes are directly supported:

    Features

    Yale describes Assure Lever Touchscreen with Z-Wave Plus as having the following features:

    • Battery Quantity
    • Battery powered using AA batteries
    • Door Lock Type
    • Firmware updatable via a compatible Z-Wave gateway
    • IP (Ingress Protection) Rated
    • Outdoor Use
    • Sensors
    • Supported Notification Types
    • FLiRS capable
    • Supports Network Wide Inclusion
    • Supports Z-Wave Explorer Frames
    • Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via

    Installation instructions

    Factory reset Assure Lever Touchscreen with Z-Wave Plus

    Remove the battery cover and batteries.
    Remove the interior escutcheon to access the reset button.
    The reset button is located above the PCB cable connector.
    While pressing the reset button for a minimum of 3 seconds, reinstall batteries. Release reset button.
    Replace battery cover.
    Please use this procedure only when the network primary controller is missing or otherwise inoperable

    Enter the 4-8 master Pin code followed by the gear key.
    Press the 7 key followed by the gear key
    Press the 1 key followed by the gear key

    Enter the 4-8 digit master pin code followed by the gear key
    Press the 7 key followed by the gear key
    Press the 3 key followed by the gear key

    Please note that this is a user manual Assure Lever Touchscreen with Z-Wave Plus from Yale Locks & Hardware is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Assure Lever Touchscreen with Z-Wave Plus and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.